The estimation of water hardness as applied to boiler water and other water is great interest for the chemical industry in general.the determination of water hardness has always been an especially important factor in the manufacturing control of sugar industry,
To Determine total hardness of Water sample in terms of Caco3 by EDTA Titration method using Eriochrome black T indicator – Chemical Practical
Eriochrome Black T is a complexometric indicator that is used in complexometric titrations, which is mainly used to determine total hardness of Water. In the below photo you can see that in its deprotonated form, Eriochrome Black T is blue. It turns red when
Determination of Coefficient of discharge for Venturimeter – Fluid Practicals
A venturimeter is a device used for measuring the rate of a flow of a fluid flowing through a pipe. It consists of three parts. A short converging part: It is that portion of the venturi where the fluid gets converges.
Verification of Bernoulli’s equation using Venturimeter – Fluid Practicals
The Bernoulli Equation can be considered to be a statement of the conservation of energy principle appropriate for flowing fluids. The qualitative behavior that is usually labeled with the term “Bernoulli effect” is the lowering of fluid pressure in regions
To calibrate the given Rectangular Notch – Fluid Practicals
A Notch is regarded as an orifice with water level below its upper edge. Notch is made of a metallic plate and its use is to measure the discharge of liquids. These are used for measuring the flow of water
Determination of Coefficient of discharge for Orifice Meter – Fluid Practicals
An orifice meter is a conduit and a restriction to create a pressure drop. An hour glass is a form of orifice. A nozzle, venturi or thin sharp edged orifice can be used as the flow restriction. In order to
To calibrate the given Trapezoidal Notch – Fluid Practical
A Notch is regarded as an orifice with water level below its upper edge. Notch is made of a metallic plate and its use is to measure the discharge of liquids. These are used for measuring the flow of water
To calibrate the given V-notch – Fluid Practicals
A Notch is regarded as an orifice with water level below its upper edge. Notch is made of a metallic plate and its use is to measure the discharge of liquids. These are used for measuring the flow of water
Determination of Metacentric Height Experimentally- Fluid Practicals
When a ship heels, the centre of buoyancy of the ship moves laterally. It might also move up or down with respect to the water line. The point at which a vertical line through the heeled centre of buoyancy crosses
To measure the flow and work ability of concrete by using Flow Table – Concrete Practical
In its simplest form, concrete is a mixture of paste and aggregates, or rocks. The paste, composed of portland cement and water, coats the surface of the fine (small) and coarse (larger) aggregates. Through a chemical reaction called hydration, the